Synergy Rear Coil Springs 4.0″ Lift for 2020+ Jeep Gladiator JT

Synergy Jeep JT Multi-Rate Rear Lift Coil Springs. Synergy has designed these springs from a clean sheet for the new Gladiator platform. All springs are multi-rate and have been designed to make a great platform even better. These springs are unique to the JT and not shared with any other vehicles. Multi-rate design has a soft initial rate which prevents the spring from coming loose, even with long travel shocks. The ride rate is the average of the OEM spring rates to maintain adequate payload and towing capacity. Springs are proudly manufactured in the United States of the highest quality steel. Springs are designed to be able to set solid (fully collapse) without overstressing the material and are pre-set from the factory meaning the springs will never sag or set.
Fitments:
Part # Lift Height Spring Rate (Initial/Ride Rate) Collapsed Length Extended Length Min. Bump Stop Spacing
8865-10 1” 165/250 lb/in 7.89″ 19.375″ 0″
8865-20 2” 165/250 lb/in 7.89” 20.375” 2”
8865-30 3” 165/250 lb/in 7.89” 21.375” 2”
8865-40 4″ 165/250 lb/in 9.46″ 22.375″ 2”
8865-50 5” 165/250 lb/in
9.5″ 23.375″ 2″
8865-60 6” 165/250 lb/in
9.5″ 24.375″ 2″

Ride Height Chart for Jeep JT Models:
Note:
Lift heights are based off fully loaded Rubicon 3.6L models with HD front and rear bumpers and winch
Measurement is over stock height for that particular model
Spring
Part # Sport
Rubicon
Rubicon
Diesel
Non-Rubicon
Diesel Jeep JT Mojave
8865-10 1″ 1″ -1″ 0″
-1″
8865-20 2″ 2″ 0″ 1″ 0″
8865-30 3″ 3″ 1″ 2″ 1″
8865-40 4″ 4″ 2″ 3″ 2″
8865-50 5″ 5″ 3″ 4″ 3″
8865-60 6″ 6″ 4″ 5″ 4″

Benefits:
Increased ride quality
Increased wheel travel/articulation/traction
No spring bowing
Lifetime warranty/guarantee against sagging and breakage
Features:
Multi-Rate coil springs allow for longer spring lengths and increased travel
Spring rates are similar to stock to maintain payload and towing capacity
Coil spring block heights designed around common bump stop spacings to optimize wheel travel
Frequency balanced and tuned spring rates to maximize suspension performance on and off road
Abrasion-resistant black powder coat finish for maximum durability and corrosion resistance
Sold in pairs
Includes:
(2) Rear Coil Springs
Notes:
Coil springs require proper bump stop spacing with Synergy 8057-10 Bump Stop Spacers.
Lift heights are based off fully loaded Rubicon 3.6L models. Other models will see more lift.
Coil springs retain the stock rake of the vehicle.
For a level ride JT Gladiators need a 1 or 2 inch taller spring in the front compared to the rear depending on model.
Up to .75 inch of front coil spring spacer can be added to help level the vehicle using 8017-075 front coil spring spacers.
Minimum bump stop spacing listed is the minimum amount of bump stop spacing required to prevent the springs from going into coil bind. Do not use less bump stop spacing.
Installation Instructions
More information: www.p65warnings.ca.gov