Bilstein 0-2.8″ Assembled Front Lift 6112 Coilovers, 5160 Rear Reservoir Shocks for 1995-2004 Toyota Tacoma

Description
Bilstein 0-2.8″ Assembled Front Lift 6112 Coilovers, 5160 Rear Reservoir Shocks for 1995-2004 Toyota Tacoma

Bilstein 0-2.8″ Front Lift 6112 Pre-Assembled Coilovers + 5160 Rear Reservoir Shocks – 1995.5-2004 Toyota Tacoma

Part: 6112Tac95-ASB

Give your first-gen Tacoma real front travel and heat management out back. This package combines pre-assembled Bilstein 6112 front coilovers with Bilstein 5160 remote-reservoir rear shocks for an adjustable 0–~2.75–2.8″ front lift, stable on-road manners, and fade-resistant control off-road. Add upper control arms, a diff-drop kit, or rear lift springs from the dropdown to tailor the setup to your build.

What’s Included

• Front (assembled coilovers): Bilstein B8 6112 kit 47-310896 – two 60 mm monotube struts, matched cold-wound springs, billet spring seats, new mounts and hardware, assembled for a no spring-compressor install
• Rear: Bilstein B8 5160 remote-reservoir shocks (pair) for 0–1.5″ rear lift

Front 6112 Highlights

• Adjustable 0–~2.75″ via snap-ring perch positions (actual lift varies by trim and added weight)
• 60 mm body & piston – bigger oil capacity and digressive control for rough terrain
• Vehicle-specific valving, monotube construction, matched linear springs
• Made in the USA

Rear 5160 Highlights

• Remote reservoirs increase oil volume and cooling for consistent damping
• Monotube, digressive valving; 360° swivel banjo fitting for clean routing
• Left shock: collapsed 12.95 in, extended 20.66 in
• Right shock: collapsed 13.42 in, extended 21.73 in
• Designed for trucks with 0–1.5″ rear lift (shocks do not add lift by themselves)

Options (select from dropdown)

• Upper Control Arms (UCAs) – improve alignment/caster at higher lift settings
• Front diff-drop kit – helps CV angles when lifted
• Rear lift – springs/add-a-leafs to match front height

Fitment

• Vehicle: Toyota Tacoma 1995.5, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004
• Front lift range: 0–~2.75–2.8″ with 6112 coilovers
• Rear support: 0–1.5″ rear lift components

Why You’ll Like It

• Pre-assembled fronts – faster, safer install
• Bigger piston, bigger control – 60 mm 6112s smooth chop while keeping steering precise
• Fade-resistant rears – 5160 reservoirs manage heat on long, rough sections

Technical Notes

• Set perch height to your target stance; higher settings may benefit from UCAs
• Alignment is required after installation
• Tire clearance depends on wheel width/offset and alignment – verify after install

FAQ

Do the fronts come assembled? Yes – the 6112s are shipped as complete coilover units.

Will the 5160s add rear lift? No – they’re valved and sized to work with up to 1.5″ rear lift components.

Which perch should I use? Many builds start mid-range for a level stance; adjust based on bumper/winch weight and desired rake.