OME 2.5″ Front Lift Assembled Coilovers for 2007-2021 Toyota Tundra

SKU: OME-FR07-TUN
Sale!
OME 2.5" Front Lift Coilovers for 2007-2021 Toyota Tundra
OME 2.5" Front Lift Coilovers for 2007-2021 Toyota Tundra

Description
OME 2.5″ Front Lift Assembled Coilovers for 2007-2021 Toyota Tundra

OME 2.5″ Front Lift Pre-Assembled Coilovers – 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021 Toyota Tundra

Dial in a true 2.5″ front lift and keep factory-like control with a bolt-on coilover package built for real-world loads. This front-only kit uses OME Nitro+ 93018 struts and OME 4017 coils, professionally pre-assembled with new top mounts and hardware so you skip the spring compressor and bolt them in with confidence. Height is set via the included perch rings to compensate for added accessories like bull bars and winches, helping you maintain your target ride height and stance.

Part number: OME-FR07-TUN

What’s Included

  • 2 x OME Nitro+ front struts (93018)
  • 2 x OME front coil springs (4017)
  • New strut mounts, isolators, dust boots, and assembly hardware
  • Pre-assembled coilover units set to your chosen load option

Why You’ll Like It

  • No spring compressor needed – arrives fully assembled for a faster, safer install
  • Genuine OME match – shocks and coils tuned to work together for controlled ride and handling
  • Load-compensated height – snap-ring perch positions let us set the front to suit added accessories
  • Real-world durability – Nitro+ struts built for rough roads, towing, and overlanding

Choose Your Load Option

We set the strut perch position during assembly to match your truck’s constant front weight. Pick the option that best describes your setup:

  • Stock Weight – no front accessories
  • Alloy Bull Bar Only
  • Steel Bull Bar Only
  • Bull Bar & Winch
  • Bull Bar, Winch & Accessories – highest front load (e.g., dual batteries, skid plates, lights)

Note: Actual lift will vary with added weight and may settle slightly after initial kilometres.

Fitment

  • Vehicle – Toyota Tundra 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021
  • Drivetrain – 2WD or 4WD
  • Lift – targets approximately 2.5″ front with appropriate load setting

Technical Notes

  • Front-only coilover package
  • Alignment is required after installation
  • Torque all hardware to manufacturer spec and re-check after initial drive
  • For best results, pair with appropriate rear springs and shocks

FAQ

Do these come assembled? Yes. We pre-assemble with new top mounts and hardware and set the perch for your selected load.

How is the height adjusted? Via snap-ring perch positions on the OME strut body. We set this during assembly based on your load option.

Will this work with a heavy bull bar and winch? Yes. Choose the matching load option so we can set the correct perch height to maintain your desired lift.

Customer reviews

Reviews

There are no reviews yet.

Be the first to review “OME 2.5″ Front Lift Assembled Coilovers for 2007-2021 Toyota Tundra”

Use one of the allowed file type: jpg,png,jpeg.

    Questions and answers of the customers

      In your product description it says struts and coils are assembled. Then at the bottom it says you don’t assemble. Which is it?
    1. 0 votes
      Q In your product description it says struts and coils are assembled. Then at the bottom it says yo...... Read more answer now
      A Everything is assembled as shown in the photo.
      2. Is the OME 2612 Medium compatible with my 2011 tundra trd rock warrior?
    2. 0 votes
      Q Is the OME 2612 Medium compatible with my 2011 tundra trd rock warrior? answer now
      A yes, compatible
      3. So on my 2wd 2012 tundra I can achieve a 6in lift with the 2.5 OME 612 and 3.5 spindle lift?!
    3. 0 votes
      Q So on my 2wd 2012 tundra I can achieve a 6in lift with the 2.5 OME 612 and 3.5 spindle lift?! answer now
      A We are not sure if these coilovers can be combined with the 3.5 spindle lift We can only say for sure that these coilovers after installation will give you 2.5 ″ Notice the drop-down menu on the right side
      4. Does the OME-FR07-TUN kit come with the upper shock mounts? If not, do you sell them?
    4. 0 votes
      Q Does the OME-FR07-TUN kit come with the upper shock mounts? If not, do you sell them? answer now
      A comes as pictured OEM mounts are reused
      A The 90018 shock will come with the spring cup and nut for the top, you will have to reuse the factory upper mount and the lower shock bolt.
      5. I have a 2014 Tundra with a 6"lift, heavy duty front bumper, which is best coil over shocks for me?
    5. 0 votes
      Q I have a 2014 Tundra with a 6"lift, heavy duty front bumper, which is best coil over shocks for me? answer now
      A Do you use stock height shocks with 6'' spacers? or some longer shocks? We need to know fully extended length 9when the wheels are in the air) of your old coilovers, as lift kits can be different
      6. Are the coils the same height as the stock trd 4x4 coils?
    6. 0 votes
      Q Are the coils the same height as the stock trd 4x4 coils?
      There are no answers for this question yet. Answer now
      7. How far maximum height of spacer if I install after market UCA of my 4wd sr5
    7. 0 votes
      Q How far maximum height of spacer if I install after market UCA of my 4wd sr5 answer now
      A with or without UCAS these coilovers are for 2.5'' of front lift. It is not recommended to have more than 3'' of suspension lift without spindle and subframe crossmember mods
      8. Are these Toyota OEM springs or aftermarket?
    8. 0 votes
      Q Are these Toyota OEM springs or aftermarket? answer now
      A aftermarket ARB/OME lift coils
      9. Hello I have a 19 Tundra SR5 with the 5.7 double cab and I’m wanting to put a 2.5 or 3” leveling kit on it will this is all I need or do I have to use rear blocks also what do you recommend that I need or get
    9. 0 votes
      Q Hello I have a 19 Tundra SR5 with the 5.7 double cab and I’m wanting to put a 2.5 or 3” leveling ...... Read more answer now
      A Hello, in order to figure out how much lift you need to level please take existing measurements from center of the wheel hub to the bottom of the fender. Difference between front and rear is how much lift you need to level. https://www.suspensionlifts.com/level.png
      10. I've got a 2008 5.7L Tundra with ARB bumper and winch. I'm not looking for a lift per se, but to level the truck after the added weight to the front. Will I need a rear lift after installing this, or can I leave the rear end stock?
    10. 0 votes
      Q I've got a 2008 5.7L Tundra with ARB bumper and winch. I'm not looking for a lift per se, but to ...... Read more answer now
      A Hello, in order to figure out how much lift you need to level please take existing measurements from center of the wheel hub to the bottom of the fender. Difference between front and rear is how much lift you need to level. https://www.suspensionlifts.com/level.png now you have a truck after adding weight tilted forward? Do you know your approximate weight of the bumper and winch? In order to align your truck you need to take stiffer springs.
      11. I have a tundra 2019 sr5 2wd Do you sell this with the uca's?
    11. 0 votes
      Q I have a tundra 2019 sr5 2wd Do you sell this with the uca's? answer now
      A We can offer * * * https://www.suspensionlifts.com/shop/toyota-sequoia/light-racing-spc-adjustable-upper-control-arms/ * * * https://www.suspensionlifts.com/shop/toyota-tundra/07-and-up-toyota-tundra/icon-delta-joint-tubular-ucas-for-2007-2018-toyota-tundra/
      12. Do you recommend the heavier springs i dont have aftermarket bumpers but i do snow plow?
    12. 0 votes
      Q Do you recommend the heavier springs i dont have aftermarket bumpers but i do snow plow? answer now
      A Hello Usually we recommend stronger coils for constant loads such as a heavy bumper or a winch. If you take a stronger spring and only occasionally put on a snow plow, and the rest of the time you drive without it, this can lead to the fact that before it will be raised up and it will be a hard ride. How often do you use the snow plow?
      13. I currently have a 2015 Tundra Crewmax 4x4 with a readylift 3"/1" level, I am looking for replacement shocks and coilovers for the lift I have already. OR Are there shocks I can purchase to keep the height I have or is it recommended to remove the Readylift Level kit and replace the shocks with a 5100 setup? Im currently running 35x12.5R18 tires on 18x9 +25 offset Methods.
    13. 0 votes
      Q I currently have a 2015 Tundra Crewmax 4x4 with a readylift 3"/1" level, I am looking for replace...... Read more answer now
      A Do you need new front and rear shocks? What leveling kit do you have - spacers with stock shocks in the front?
      14. Do I need a new uca to achieve proper camber
    14. 0 votes
      Q Do I need a new uca to achieve proper camber answer now
      A UCA's are recommended but not require, the benefit of the UCA's is to  fix the caster when the vehicle is getting aligned and also helps you a  lot with articulation on the front end.
      15. Does this come with spacers? If not, what is the item number for the spacers? Can I add it to my existing order?
    15. 0 votes
      Q Does this come with spacers? If not, what is the item number for the spacers? Can I add it to my ...... Read more answer now
      A Does not come with spacers
      16. I have 2018 Tundra TRD Sport, do I need drop spacers for this item?
    16. 0 votes
      Q I have 2018 Tundra TRD Sport, do I need drop spacers for this item? answer now
      A You can go without spacers but the lift amount will be 0.5'' less without them
      17. Can I buy just the coil springs
    17. 0 votes
      Q Can I buy just the coil springs answer now
      A Yes, their price would be $179.77 Would you like 612. 613 or 614 coils ?
      18. I have a 2011 tundra with a readylift leveling kit 1 inch rear 3 inch front. If I replace the struts with ome-fr07-tun will my truck still sit level.
    18. 0 votes
      Q I have a 2011 tundra with a readylift leveling kit 1 inch rear 3 inch front. If I replace the str...... Read more answer now
      A These shocks with coils will give you 2.5'' of lift https://suspensionlifts.com/shop/toyota-sequoia/08-and-up-sequoia/3-inch-ome-front-lift-with-shocks-and-coils/ To find out will it be level or not please measure the distamce from the front and rear wheel centers (hubs) to the fender line and see what is the difference
      19. are they set at 3'' if you guys assemble them
    19. 0 votes
      Q are they set at 3'' if you guys assemble them answer now
      A Yes, they will give you about 2.5-3'' when assembled
      20. Are they pre set at 3'' if you guys assemble them
    20. 0 votes
      Q Are they pre set at 3'' if you guys assemble them answer now
      A Yes, they will give you about 2.5-3'' when assembled
      21. If I dont have you guys assemble them do they come with the top mounts and hardware still?
    21. 0 votes
      Q If I dont have you guys assemble them do they come with the top mounts and hardware still? answer now
      A No
      22. Does your install include new isolation pads also
    22. 0 votes
      Q Does your install include new isolation pads also answer now
      A Yes, assembly does include them along with all necessary hardware
      23. Do these require a compression tool to install?
    23. 0 votes
      Q Do these require a compression tool to install? answer now
      A Yes, they require. For ease of install we now offer assembly of front OME coilovers, with new top mounts and hardware for $140.00. Please choose from options.
      24. How does the rear get the lift to level out a 2008 Sequoia Platinum?
    24. 0 votes
      Q How does the rear get the lift to level out a 2008 Sequoia Platinum? answer now
      A

      We don't have anything for the rear of Sequoia 07+
      25. Doea this kit work on Platinum models?
    25. 0 votes
      Q Doea this kit work on Platinum models? answer now
      A Yes, it will work for Platinum package models 2007+ Tundra and 2008+ Sequoia.

    ATTENTION STATE OF CALIFORNIA CONSUMERS. WARNING: Cancer and reproductive harm – www.p65warnings.ca.gov

    Related products

    Base Price: Original price was: $859.00.Current price is: $709.95.

    In stock

    In stock

    • We will assemble coilovers for you with new top mounts, bushings, hardware. Processing times may take 2-7 days.
    Share (0)
    Total: 0 Total: 0 Total: 0 Total: 0