Your cart is currently empty!
Bilstein/OME 5100 1.5-3″ Lift Assembled Coilovers and Rear Shocks for 2000-2006 Toyota Tundra
Description
Bilstein/OME 5100 1.5-3″ Lift Assembled Coilovers and Rear Shocks for 2000-2006 Toyota Tundra
Bilstein/OME 5100 1.5-3″ Front Lift Pre-Assembled Coilovers + Rear Shocks – 2000-2006 Toyota Tundra
Part: BTU00CS
Give your first-gen Tundra confident control and a true front lift with a matched Bilstein and OME package. The front Bilstein 5100 struts are pre-assembled with ARB/OME front coils and new top mounts, so you skip the spring compressor and bolt them in. Rear Bilstein 5100 shocks complete the setup for balanced handling on pavement and trail.
What’s Included
- Front (pre-assembled coilovers): Bilstein 5100 struts 24-261425 with ARB/OME coils, new top mounts, bushings, and hardware
- Rear: Bilstein 5100 shocks 24-100144
Lift Range and Perch Setting
- Front lift: approximately 1.5-3″ depending on coil selection and vehicle weight
- Preset: coilovers are built on the lowest clip. OME coils provide the lift – do not raise the clip for extra lift
- Setting the clip higher can over-lift the front and may damage CVs, ball joints, or other suspension components
Why You’ll Like It
- No spring compressor needed – fronts arrive fully assembled
- Bilstein 5100 control – monotube design with 46 mm digressive piston and self-adjusting deflective-disc valving
- Matched OME coils – real-world ride height, improved wheel travel, and composed handling
Fitment
- Vehicle: Toyota Tundra 2000, 2001, 2002, 2003, 2004, 2005, 2006
- Drivetrain: 2WD or 4WD
Technical Notes
- Front body – snap-ring grooved coilover, nitrogen gas-charged
- Rear body – smooth-body 5100 shock, nitrogen gas-charged
- Alignment is required after installation
- Actual lift varies with added accessories and vehicle condition
FAQ
Do the fronts come assembled? Yes – with OME coils, new mounts, bushings, and hardware.
Can I move the front clip higher? No. This kit is intentionally built on the lowest clip because the OME coils supply the lift. Raising the clip can over-lift and cause damage.
Will the rear shocks add lift? No. They are tuned to work with the lifted front for balanced control.
Questions and answers of the customers
-
Will this set up fit on a 2005 single cab tundra long bed? Also, will it increase load capacity? Thanks
-
Q Will this set up fit on a 2005 single cab tundra long bed? Also, will it increase load capacity? ...... Read more answer nowA Yes, the Bilstein/OME 5100 1.5-3″ Lift Assembled Coilovers and Rear Shocks are compatible with your 2005 Toyota Tundra single cab long bed, assuming it has the standard suspension setup and not an aftermarket lift or modification already installed. No This kit will not increase the load capacity
These being adjustable ride height, how does that work since you select an option for life? Like if you ordered the 2.5” option is that the maximum it minimum height on your shocks?
-
Q These being adjustable ride height, how does that work since you select an option for life? Like ...... Read more answer nowA adjustable with stock (factory) coils. Not recommended to set higher clips with lifted coils like OME
I want to level my tundra, if I choose 3 inch shocks for the front will the rear struts be stock hight?
-
Q I want to level my tundra, if I choose 3 inch shocks for the front will the rear struts be stock ...... Read moreThere are no answers for this question yet. Answer now
Can I use factory upper control arms?
-
Q Can I use factory upper control arms?There are no answers for this question yet. Answer now
With the coilovers would i still be able to use my 2.5 inch leveling spacer?
-
A it is not recommended to stack lifts also over lifting the suspension more than 3'' is harmful for the truck
Is that what someone would get o level a 2006 CC Tundra SR5 4wd? what setting would they be on to level?
-
Q Is that what someone would get o level a 2006 CC Tundra SR5 4wd? what setting would they be on to...... Read more answer nowA Usually 2'' but to be sure in order to figure out how much lift you need to level please take existing measurements from center of the wheel hub to the bottom of the fender. Difference between front and rear is how much lift you need to level. https://www.suspensionlifts.com/level.png
So are the shocks a 3 inch lift it’s self or it will fit a 3inch level?
-
A Front coilovers will lift the front by themselves rear shocks can be used with stock height or with already lifted rear
Hi, what will be shipping costs for Poland? Thank You!
-
A Please tell us your full shipping addres (better via e-mail) and we'll calculate shipping
Will the rear shocks here accommodate a 1-2" lift in the rear? I will be upgrading my rear leafs to heavy duty and expect a modest increase in ride height in the rear too. Thank you!
-
Q Will the rear shocks here accommodate a 1-2" lift in the rear? I will be upgrading my rear leafs ...... Read more answer nowA yes, rears will work with 1-1.5'' rear lift
ATTENTION STATE OF CALIFORNIA CONSUMERS. WARNING: Cancer and reproductive harm – www.p65warnings.ca.gov
Related products
-
Sale!
Bilstein 5100 0-1″ Rear Lift Shocks for 2000-2006 Toyota Tundra
(8 reviews)Original price was: $237.78.$216.16Current price is: $216.16. -
Sale!
Bilstein 5100 0-2.5″ lift front, 0-1″ rear shocks 00-’06 Toyota Tundra
(21 reviews)Original price was: $534.00.$503.56Current price is: $503.56. -
Sale!
Firestone Ride Rite air bags Toyota Tundra 2007-2018
(0 reviews)Original price was: $578.93.$526.30Current price is: $526.30. -
6 reviews for Bilstein/OME 5100 1.5-3″ Lift Assembled Coilovers and Rear Shocks for 2000-2006 Toyota Tundra