Bilstein 4600 Assembled Coilovers with OE Replacement Springs and Bilstein 4600 Rear Shocks for 2007-2021 Toyota Tundra

Description
Bilstein 4600 Assembled Coilovers with OE Replacement Springs and Bilstein 4600 Rear Shocks for 2007-2021 Toyota Tundra

Bilstein 4600 Front Assembled Coilovers with OE Replacement Springs + Rear 4600 Shocks – 2007-2021 Toyota Tundra

Part: 4600BIL7TK

Restore factory ride height and tighten control with a complete Bilstein B6 4600 package for your Tundra. The fronts arrive pre-assembled with OE-style replacement coils and new top mounts, so you skip the spring compressor. Matching rear 4600 shocks complete the setup for balanced, confident handling and everyday comfort.

What’s Included

• Front (assembled coilovers): Bilstein B6 4600 shocks 24-186230 with OE-style replacement coil springs, new top mounts, bushings, and hardware
• Rear: Bilstein B6 4600 shocks (pair). NOTE: Bilstein does NOT include rear shocks bushings with these, saying you need to reuse your existing ones. We do sell a bushing/washer kit that Bilstein includes with their other Bilstein 5100 shocks which you can purchase here

Why You’ll Like It

• No spring compressor needed – fronts come fully assembled for a faster, safer install
• Better-than-OE control – B6 4600 monotube design with velocity-sensitive digressive piston for consistent, fade-free damping
• Stock-height stance – improves stability and comfort without adding lift

Fitment

• Vehicle: Toyota Tundra 2007-2021
• Height: stock-height OE replacement (no lift)

Spring Highlights

• Designed to lower stresses for longer service life
• Helps correct sag that can cause tire wear from misalignment
• 100% load tested
• Easy to install – limited 1-year warranty

Technical Notes

• Monotube, gas-pressure construction for consistent performance
• Non-reservoir, non-adjustable
• Alignment is recommended after installation
• Assembly time: typically 2-7 business days

FAQ

Do these add lift? No – this kit maintains factory ride height.

Do the fronts come assembled? Yes – new coils, mounts, bushings, and hardware are installed.

Can I pair this with rear leaf springs for load support? Yes – add rear springs or add-a-leafs separately if you need additional rear height or payload support.