Bilstein/OME 5100 2-3″ Lift Assembled Coilovers with Rear Shocks for 2001-2007 Toyota Sequoia

Description
Bilstein/OME 5100 2-3″ Lift Assembled Coilovers with Rear Shocks for 2001-2007 Toyota Sequoia

Bilstein / OME 5100 1.5-3″ Front Lift Pre-Assembled Coilovers + Rear 5100 Shocks
2001-2007 Toyota Sequoia (2WD & 4WD)

Part #: BSE00CS

Need rear lift coils too?

What’s Included

• Front (pre-assembled coilovers)
  • 2 × Bilstein B8 5100 ride-height-adjustable struts
  • 2 × ARB / OME front lift coils (see options when ordering)
  • New top mounts, isolators, dust boots & hardware
• Rear
  • 2 × Bilstein B8 5100 rear shocks – tuned for the factory rear height

Front Coil Options

• OME 2880 – ~1.5″ lift, stock front weight
• OME 2881 – ~2-2.5″ lift, stock front weight
• OME 2883 – ~2.5-3″ lift, +200 lb front weight (steel bumper + winch)

Important Setup Note

Coilovers are built on the lowest snap-ring clip. The lift comes from the coils themselves. Do NOT set the 5100 perch higher – over-lifting can damage CVs & ball joints and voids warranty.

Why You’ll Like It

• No spring compressor needed – fronts arrive fully assembled
• 46 mm monotube control – digressive valving for smooth highway ride and extra off-road travel
• Matched rear 5100s – keeps handling balanced front & rear
• Direct bolt-on – retains factory sway-bar, brake-line brackets, etc.

Fitment

• Toyota Sequoia 2001 · 2002 · 2003 · 2004 · 2005 · 2006 · 2007
• 2WD or 4WD, stock rear coils
• Front lift range depends on coil choice & accessory weight (≈1.5-3″)

Specifications

Install & Warranty

• Ships pre-assembled – typical lead time 3-6 business days
• Alignment required after installation
• Bilstein limited lifetime warranty on dampers; 3-year ARB/OME warranty on coils

FAQ

Will the rear shocks lift my truck? No – they’re valved for the factory rear coils. Choose the “kit with rear coils” if you need rear lift.

Can I later raise the snap-ring? Not recommended when using lift coils; doing so can over-lift and damage suspension components.