Bilstein 4600 Assembled Coilovers with OE Replacement Springs for 1995-2004 Toyota Tacoma

Description
Bilstein 4600 Assembled Coilovers with OE Replacement Springs for 1995-2004 Toyota Tacoma

Bilstein 4600 Front Assembled Coilovers with OE Replacement Springs – 1995-2004 Toyota Tacoma

Part: 4600BIL95T

Refresh ride quality at stock height with a direct-fit front suspension upgrade. These assemblies use Bilstein B6 4600 shocks 24-022842 pre-assembled with new Moog/Mevotech OE-replacement coil springs and top mounts, so you skip the spring compressor and bolt them in with confidence.

Need a full front/rear kit?

What’s Included

• 2 x Bilstein 4600 front shocks 24-022842
• 2 x Moog OE-replacement front coil springs
• New top mounts, isolators, dust boots, and hardware
• Professionally pre-assembled coilover units – ready to install

Why You’ll Like It

• No spring compressor needed – faster, safer install
• Better than stock control – B6 4600 monotube design with velocity-sensitive digressive piston for consistent, fade-free damping
• Stock-height stance – restores ride and handling without adding lift
• Moog/Mevotech springs – load tested to combat sag and help maintain alignment

Fitment

• Vehicle – Toyota Tacoma 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004
• Height – stock-height OE replacement (no lift)

Spring Highlights

• Designed to lower stresses for longer service life
• Helps prevent tire wear from sag-induced misalignment
• 100% load tested
• Easy to install – limited 1-year warranty

Technical Notes

• Bilstein B6 4600 monotube, gas-pressure construction
• Non-reservoir, non-adjustable
• Alignment is recommended after installation

FAQ

Do these add lift? No, they maintain factory ride height.

Do they come assembled? Yes, with Moog or Mevotech coils, new mounts, and hardware.

Can I pair these with rear shocks? Yes – choose the full kit here: